 | | Re: question on mindstorm capabilities for competition
|
|
(...) Hi George, NXT will do this fine, however you might want to try two light sensors (1 more than in the Retail Kit) Otherwise you might not be able to tell going off line and a break in the line! The NXTG language would be fine for this task and (...) (16 years ago, 4-Jul-08, to lugnet.robotics)
|
| |
| | Re: AW: Assembly line feeding system
|
|
(...) Hello Jordan, Thanks a lot for the tip! This is an amazinly simple and effective way to serialize a ball flow. According to my experiments, there is a little thing to add to your explanations: the narrow ramp level must be sufficiently lower (...) (16 years ago, 4-Jul-08, to lugnet.robotics)
|
| |
| | Bluetooth quirks
|
|
I've just re-read Sivan Toledo's "Analysis of the NXT Bluetooth Communication Protocol" tacked on the main lugnet.robotics.nxt main page. I am currently in a PC lab (Portland State Univ NH 439) with 9 bright kids. We have about 24 NXT kits at our (...) (16 years ago, 2-Jul-08, to lugnet.robotics.nxt)
|
| |
| | Re: AW: Assembly line feeding system
|
|
GBC module creators tend to independently reinvent the same hopper solutions used in factories. Some of them shake, many of them have an agitator spinning inside it to loosen the pieces, but the simplest just use gravity and a change of direction. (...) (16 years ago, 2-Jul-08, to lugnet.robotics)
|
| |
| | AW: Assembly line feeding system
|
|
Maybe a look into actual GBC designs and their approaches to transportation might prove useful (?). (Ok, it's for LEGO balls instead of plates) (URL) Nachricht----- Von: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] Im Auftrag von John (...) (16 years ago, 2-Jul-08, to lugnet.robotics)
|
