 | | RE: nxt controller specification
|
|
Thank you for clarifying this, Brian. I was reading (URL) It stated that the NXT with "Stalled torque) up to 50 N.cm. 50N... it equates approximately 10lbs?! That is without any further gearing down, but just the NXT motors!? Wonder if anyone has (...) (18 years ago, 13-Feb-08, to lugnet.robotics.nxt)
|
| |
| | Re: PF IR RC protocol released! - NXC
|
|
(...) Many thanks John and Jason for your work on this. I am a comparative newbie to NXC programming but I have my NXT working like a PF IR remote handset now that I set up the sensor correctly! NXC has given me the programming environment to (...) (18 years ago, 5-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
| |
| | Re: Power Functions infra-red RC protocol released!
|
|
(...) Many thanks John and Jason for your work on this. I have been using the NXC functions to control PF IR receivers from my NXT. TLG has just released the following information: "We have been testing the LPF RC Receiver today and discovered an (...) (18 years ago, 6-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
| |
| | Re: nxt controller specification
|
|
(...) Yes. The AVR is responsible for a number of things, including PWM and encoder reading on the motor ports (IMS), the reading of the front panel button state, power management, and A/D from the input lines for analog sensors. It is not (...) (18 years ago, 13-Feb-08, to lugnet.robotics.nxt)
|
| |
| | nxt controller specification
|
|
Hi, I wonder if anyone may be familiar with the spec about the nxt brick: I found this on the ww.hobbyengineering.com . NXT Brick * 32-bit ARM7 microcontroller * 256 Kbytes FLASH, 64 Kbytes RAM * 8-bit AVR microcontroller * 4 Kbytes FLASH, 512 Byte (...) (18 years ago, 13-Feb-08, to lugnet.robotics.nxt)
|
