 | | Re: Touch Sensor Actuation Force?
|
| (...) I don't, but I can tell you that it's trivial. The main issue is the distance the switch needs to be pushed before it triggers, not how hard it's pushed. I've built 'frames' around the sensor such that an almost infinitesimal bump triggers the (...) (28 years ago, 21-Oct-98, to lugnet.robotics, lugnet.build)
| | |  | | Re: Questions about sensors
|
| Eric Noyau wrote: <snip> (...) The results you get from a reflective IR sensor will vary quite a lot depending on surface color, roughness, angle of incidence, electrical noise, etc. My IR sensors were not good for much of anything besides encoders, (...) (28 years ago, 21-Oct-98, to lugnet.robotics.handyboard)
| | |  | | Re: Charging batteries
|
| (...) Well I will be the first to admit that this is hardly a scientific study but here is my personal experience. For 4 years I have had the same cellular phone and the same notebook computer. The cellular phone is a Motorola with an Intelecharger (...) (28 years ago, 21-Oct-98, to lugnet.robotics)
| | |  | | Basic Sensor Question
|
| I just got my HB and am trying to test the sensor input, the docs say to hook up the microswitch between signal and ground, when I do this and close the switch my hb resets (because I just shorted it out...). I tried putting a resistor (330 ohm) in (...) (28 years ago, 21-Oct-98, to lugnet.robotics.handyboard)
| | |  | | RE: RTOS for HB?
|
| There is the Micro Kernel from Jean J. Labrosse. It's a free kernel readily available, also for the 68hc11. I have his book but haven't implemented the full kernel yet, only parts of it. Its well written and cheap. Look at: (URL) jaron paludanus (...) (28 years ago, 21-Oct-98, to lugnet.robotics.handyboard)
| |