 | | RE: Progressing from RCX to NXT
|
|
Did they use Robolab to teach at the summer camp? If so, he could also use it to program the NXT; just make sure you obtain Robolab 2.9 version which supports both RCX and NXT; version 2.5 is RCX only. -----Original Message----- From: (...) (19 years ago, 1-Jul-07, to lugnet.robotics.nxt)
|
| |
| | RCX Code - Light Raw Values
|
|
Hi people, Its possible to configure/read RAW light sensor values with RCX CODE? I think i saw it sometime ago, but i could not find it. Thanks in Advance Patrick J. Levy ___...___ Omiccron Programação Gráfica Ltda. 11 3288-4832 (...) (19 years ago, 30-Jun-07, to lugnet.robotics.rcx)
|
| |
| | Re: Custom firmware crashing on boot
|
|
Sorry I didn't have time to reply to your post yesteday; I had limited time available. (...) Hmm, as I said yesterday to Dick, disabling all three binsert calls in the makefile caused my firmware to crash on a blank screen, even after I had done (...) (19 years ago, 29-Jun-07, to lugnet.robotics.nxt.nxthacking)
|
| |
| | NXT & RIC
|
|
A while back I wrote part 1 of a 2 part description of the RIC file format on the Nxtasy blog. I still haven't gotten around to writing part 2 (been busy writing other stuff) but RIC-related things have been hanging around on the edges of my (...) (19 years ago, 29-Jun-07, to lugnet.robotics.nxt)
|
| |
| | Re: Adding a JTAG port?
|
|
(...) I used a JTAG tool in the beginning by glueing a JTAG connector manually. You could do that and perhaps have a look at section 4.3 in (URL) it is easier to use libnxt. I am using it in this project: (URL) can download libnxt source from (or of (...) (19 years ago, 29-Jun-07, to lugnet.robotics.nxt.nxthacking)
|
