 | | Re: Newbie needs Help (diff sensor)
|
|
(...) Quite true. My bad. -dave (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help (diff sensor)
|
|
(...) I think you need another pair of gears on one of the wheels to reverse its direction. If you are going to use a rotation sensor to measure the slippage then you need to realise that the sensor is notoriously poor at very low speeds. You'll at (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) What I'm saying is that if the robot is moving along at (say) 3 inches per second - then the drive wheels will get most traction if they are turning at a speed equivelent to 3 inches per second. If they are rotating faster than that (because (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help (diff sensor)
|
|
Some varied thoughts here: (...) I might be wrong, but my understanding of the Lego differential gearing is that if both shafts are turning at the same rate and direction, the outer gear/shell will turn at the same rate as the axles. Only when the (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) Raj, There's a bit of confusion here. I believe the above quote actually came from Steve Baker (posting only as Steve). As Steve Baker pointed out, there is a difference between kinetic (sliding) friction and static friction. ((URL) In the (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) Ummm.... that's not the way I remember the mechanics. There is a torque created that is force on the drawbar times the drawbar height from ground. That torque will lift your front end. Doubling your own drawbar height halves your pulling (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) One rotation sensor and a differential will allow you to compare the rotation of two wheels. If the driven wheel and the undriven wheel come in the two sides of the differential, and the rotation sensor is connected to the drive ring, then the (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) Dean, Thank you for your response. I am going to get on with the tow rope suggestion right away. You might like to know that your 2002 'Building Lego Robots for FLL' guide was the first thing that I read. Raj (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
You only need one rotation sensor and some fancy gearing. Using a differential in a way similar to the "South Facing Cart" or the stearing drive in a dual differential setup, you could directly measure the amount of spin between a driven wheel and (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Newbie needs Help
|
|
(...) Steve, One rotation sensor is allowed. There are also two light sensors, so your idea is definitely doable. The situations that are confusing are when the pull of the other robot prevents your robot from making any headway, as well as when (...) (20 years ago, 6-Jun-06, to lugnet.robotics)
|