To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4371 (-5)
  WARNING: +5 supply exposed
 
Take a moment to look at your Handy Board. There is a thick trace along the top, right and bottom edge. This is your regulated +5 line. Now look very closely at the outer edge of this trace. It should be completely green (covered with solder mask). (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
 
  My problems with digital outputs
 
Dear Mr Fred Martin, My project requires digital outputs and does not need to have motor outputs. I have also read your FAQ and one of them states that by adding a hc374 IC chip in a similar fashoin to the one driving the motor circuits, and (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
 
  Re: analog problems
 
Dear Sam, It is so strange as you already replace all the chips. The "testanalogs()" is used to test A/D feature and analog port of MC68HC11. It will prompt you "Press START to test knob..." You then press START button and the reading of A/D port (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
 
  analog problems
 
I am building my handyboard and have been unable to succesfully execute testanalogs(). testmotors(); and testdigitals(); work but when i testanalogs(); either the board displays the current position of the knob (1-256) and freezes, displays the (...) (28 years ago, 11-Sep-98, to lugnet.robotics.handyboard)
 
  Re: Ramping up and down.
 
(...) Not quite, but I made good use of the PWM to provide automatic, feedback-adjusted motor control for straight-line tracking. It might give you some ideas. My 'bot uses differential steering (it looks like a small wheelchair) and used to cruise (...) (28 years ago, 11-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR