To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *43504 (-5)
  Re: mindstorms NXT
 
(...) You can connect some technic bricks to the sides and have studded bricks very easily. Studless design allows you to access the batteries, display, and buttons much easier. Also technic connection are significantly stronger than the old (...) (21 years ago, 5-Jan-06, to lugnet.robotics, FTX)
 
  Re: mindstorms NXT
 
(...) Right. You cant always do things mechanically as it would complicate the design and might be too far apart. Also, sometimes a single motor doesnt have enough power, so doubling it up helps.... Ram (21 years ago, 5-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) I will speculate with you here. If I was a betting man, I would bet that they just made 3 of them "motor" ports because of power limitations. I highly doubt they used USB. Of course, you could always plop a usb hub into that port and make your (...) (21 years ago, 5-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) Actually, the RCX outputs 0's and 1's to power the motors as it is right now. It uses Pulse Width Modulation (PWM). Basically for 1/3 power 1/3 of the pulse is 1 and the other 2/3 is 0. For full power, the signal is all 1. This creates a (...) (21 years ago, 5-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) Speculation: I think we're looking at some sort of i2c-like type interface here, where you'll find continuous power on one of the pairs and the other two pairs being used as some sort of high-speed digital bidirectional full-duplex or (...) (21 years ago, 5-Jan-06, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR