 | | Re: Barcodes & error detection
|
|
(...) I actually started out this way, before getting lost in the number of combinations. After you suggested it, I may actually reconsider, because: (...) Perhaps less; right now the reflective strips don't really encode information, they just (...) (21 years ago, 8-Sep-05, to lugnet.robotics)
|
| |
 | | Re: Barcodes & error detection
|
|
(...) Agreed, and, for this application, the bit overhead to allow on-board correction is probably just not worth it. After all, if an error is detected, the forklift can always back up and try to read the barcode again. (...) Almost exclusively (...) (21 years ago, 8-Sep-05, to lugnet.robotics)
|
| |
 | | Re: Barcodes & error detection
|
|
Thanks, you actually made me pull out one of my old comp sci texts :-) I remembered studying this stuff many moons ago .... Error detecting requires a "distance" between codes of at least TWO ... what this means is to detect a single bit error each (...) (21 years ago, 8-Sep-05, to lugnet.robotics)
|
| |
 | | Re: Barcodes & error detection
|
|
(...) Well, there is a sharp distinction between error DETECTION and error CORRECTION. It's also important to characterize the errors you are getting. Are you getting single bit errors or multi-bit errors? You will certainly need to use more bits in (...) (21 years ago, 8-Sep-05, to lugnet.robotics)
|
| |
 | | Re: Barcodes & error detection
|
|
(...) Right off hand I don't know any checking mechanism that works best with false readings of one polarity. Do you know anything about Error Correction Codes? ECC is used to detect and correct single bit errors, it can also detect double bit (...) (21 years ago, 7-Sep-05, to lugnet.robotics)
|