 | | what is poke and peek command
|
| Hi, How to understand what is poke( 1009, 0x20) and bit set (1008, 0x20) ? What is 0 x20 and 0x30 ? how to interpret it ? when should I use 0x20 ,0x30, or 0x40 ? what is all these ? Please advice ? I need to understand it so that I can proceed to (...) (28 years ago, 6-Aug-98, to lugnet.robotics.handyboard)
| | |  | | Re: Pull Up Resistor
|
| I checked the ECHO signal and found it to be at 2.0V when plugged into TIC3 on the HB. I also applied a pull-up resitor which did send ECHO to 5V when not pinging. However, in both cases, I still had seemingly random positive and negative values (...) (28 years ago, 6-Aug-98, to lugnet.robotics.handyboard)
| | |  | | Re: Pull Up Resistor
|
| (...) I just checked my copy of the Polaroid Sonar Module documentation, and it does in deed state that the module can sink up to 0.1 mA when ECHO is pulled high. It sounds like your module is drawing around 0.064 mA = ((5V - 2V)/47Kohms), so it is (...) (28 years ago, 6-Aug-98, to lugnet.robotics.handyboard)
| | |  | | Re: Pull Up Resistor
|
| (...) One more thought. I assume you are using a seperate supply (of some sort) for the Sonar module, so be sure to tie the pullup to the HB's +5V! Rick (28 years ago, 6-Aug-98, to lugnet.robotics.handyboard)
| | |  | | Interfacing I2C devices
|
| Can the HandyBoard interface to I2C devices through it's SPI (or otherwise) port? If so, does anyone have the source code to do so? I am interfacing the National LM4832 chip to it. Thanks in advance. (28 years ago, 7-Aug-98, to lugnet.robotics.handyboard)
| |