To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *41534 (-5)
  Re: Technic plates
 
(...) This sounds like a good idea. What size drill bit did you end up using? (22 years ago, 14-Jan-05, to lugnet.technic, lugnet.robotics)
 
  Technic plates
 
I was just putting together the classroom packs I use for teaching robotics. Each two student team is given a tray of "standard" parts to work with. To make life easier I have tried to "color-coded" these sets with all components (as much as (...) (22 years ago, 14-Jan-05, to lugnet.technic, lugnet.robotics) ! 
 
  Re: combining LDCC and NQC style automation?
 
(...) If you'd rather do a little hardware work, than learn pbForth, I have a couple suggestions. 1) You could use LEDs instead of regular lights. An LED will only light, when the power is going the correct direction. So you could connect 1 LED to (...) (22 years ago, 14-Jan-05, to lugnet.robotics.rcx, lugnet.trains)
 
  Re: combining LDCC and NQC style automation?
 
[big snip] (...) I do have DCC in the latest pbForth, but I've sort of dropped official support for older versions of MacOS. That being said, I think the instructions are still up on the site for getting it to work. :-) Please post here if you;re (...) (22 years ago, 14-Jan-05, to lugnet.robotics.rcx, lugnet.trains)
 
  Re: combining LDCC and NQC style automation?
 
Christopher Masi wrote: [snip] (...) [snip] (...) I know, replying to myself, bad form. I have also discovered that pbForth has DCC worked into it. The good new here (although I have only looked at the introduction on the home page) is that Raplph (...) (22 years ago, 14-Jan-05, to lugnet.robotics.rcx, lugnet.trains)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR