 | | Re: The Great Ball Contraption
|
|
(...) The standard doesn't explain this very well, because I'm really not sure how to write it. A module can be any size, but the input and output should be on opposite sides, with the front of the input being no more than 32 studs from the back of (...) (22 years ago, 7-Jan-05, to lugnet.robotics)
|
| |
 | | RE: The Great Ball Contraption
|
|
(...) I happen to have a LEGO basketball set on my desk... Eyeing it up against a ruler, it is 14mm in diameter. Depending on design choice, one might consider using only LEGO basketballs or soccer balls because other materials would have different (...) (22 years ago, 7-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) This post will be overkill I am sure but this Bricklink store sells has 42 soccer balls $.10 US a piece (URL) (22 years ago, 7-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) I'll point out that the standard as it's defined pictorially allows for a non-linear layout just as it stands. As long as the input in in the correct place relative to the previous block's output, and the output is placed correctly relative to (...) (22 years ago, 7-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) I'd really recommend against using anything but LEGO balls. If you just want to play around and test, one good place to get a couple balls are the LEGO NBA sets. I've seen them on sale all over. Using any other type of balls will not give you (...) (22 years ago, 7-Jan-05, to lugnet.robotics)
|