 | | Re: Connecting radio module (BiM 418 F)
|
|
Hello all, I was surprised to see one of my old postings on this list appear again this week. The problem I posed here has been solved, and the results can be found via this page: (URL) Sipke van der Veen (28 years ago, 7-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | RE: check_sensors.c
|
|
Terry, It seems that alot of the problems with this piece of code are syntax errors, you could correct alot of these by looking up the secific syntax in the HB manual and there may or may not be a few things that I would have done differently (...) (28 years ago, 7-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | stepper motors: choosing an approach
|
|
There appears to be much interest in using the handyboard to control stepper motors. Choosing the right approach depends on what you want your robot to do. There are a number of specialized boards for controlling stepper motors, but they are (...) (28 years ago, 7-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Inclinometer for Handyboard
|
|
Hello, I've been searching, without much luck for a single axis inclinometer with a reasonable settle time and +-30 degree resolution, for less than $50. Anyone have any leads? Thanks, Aaron (28 years ago, 7-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Interrupt Handler for Serial communication
|
|
Here's a bit of code that will buffer incoming serial information so that no information will be lost when transmitting to the handy board. There are two files: serial_isr.c and serial_isr.asm. You'll need to assemble the .asm file using as11_ic, (...) (28 years ago, 7-Jul-98, to lugnet.robotics.handyboard)
|