 | | Re: Control Cybermaster from RCX with feedback
|
|
(...) It might be theoretically possible to use one RCX sensor port for control of the cybermaster - and using the one motor and one sensor port on the cybermaster. A few multiplexing designs I've seen use switching between passive and active sensor (...) (22 years ago, 10-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| |
 | | Control Cybermaster from RCX with feedback
|
|
Is it possible to interface a cybermaster and an RCX without the use of a PC, also without using up all sensor and motor ports? Sincerely, Morten H Pedersen (22 years ago, 10-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| |
 | | Re: Straight moving with only one rotation sensor
|
|
(...) Sounds good. I use a CyberMaster for the movement part of the robot because it has tachos on each internal motor. I modify the power settings for the motors to keep the robot (reasonably) straight, rather than stop and start them. If you tried (...) (22 years ago, 10-Jun-04, to lugnet.robotics.rcx.nqc)
|
| |
 | | Straight moving with only one rotation sensor
|
|
Hi I saw in the LEGO Mindstorms Web Page that many people made their robots with 2 motors go straight using one rotation sensor on each wheel and stopping the correct motor until both sensors were equal. I got Ultimate Accessory Set as a present (...) (22 years ago, 10-Jun-04, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: lego pneumatic
|
|
(...) Good reasearch..... Using the mindstorm motors, who's torque is a good match for the small pump, the small pump gets to a static pressure faster than a large pump using hte same kind of motor. The small pump does not keep up with the total (...) (22 years ago, 9-Jun-04, to lugnet.robotics.rcx.legos, lugnet.technic)
|