 | | Re: 6293 rc receiver Auxiliary output possible?
|
|
thanks for checking Mark! that is more help than i expected. too bad it's not going to work. guess i'm going to have to buy another receiver from bricklink if i really want the extra output. bob (...) Bob Kojima ko@fial.com Fial Incorporated Telecom (...) (23 years ago, 15-Apr-04, to lugnet.technic, lugnet.robotics)
|
| |
 | | carousel on MOCpages
|
|
I've finally finished the write-up of my carousel at (URL) to .spybotics because it's Spybot powered. (23 years ago, 15-Apr-04, to lugnet.robotics.spybotics, lugnet.technic, lugnet.town)
|
| |
 | | Re: Differences between Raw Sensor readings and Light Sensor
|
|
(...) I'd guess it depends on what you are doing. Without a doubt, raw gives you the best sensor resolution. I'd guess that for kids it is easier to think in terms of 0 to 100%. Since you are not a kid, raw is probably better. (...) Kevin (23 years ago, 15-Apr-04, to lugnet.robotics.rcx)
|
| |
 | | Re: 6293 rc receiver Auxiliary output possible?
|
|
(...) Hi Bob, I opened two of my receivers, one was from set 8376 Hot Flame and the other was from set 8475 RC Buggy (I actually purchased this second receiver from BrickLink just to get the third output). The first thing I noticed is that the motor (...) (23 years ago, 14-Apr-04, to lugnet.technic, lugnet.robotics)
|
| |
 | | Differences between Raw Sensor readings and Light Sensor
|
|
Hi, Can someone point out the differences between setting a sensor as Light (or any custom sensor) vs setting the sensor as Raw? Isnt it better to use the RAW readings since it reports a range of 0 to 1023 as opposed to scaling the readings to 0 to (...) (23 years ago, 14-Apr-04, to lugnet.robotics.rcx)
|