 | | r22 Code
|
|
I am using a Sony IR and also use the sony-ir.icb code. But I am curious what is the r22 ir code for? I also understand that if I use the sony-ir that I should not use the r22 but I'd like to know what it is for anyway. (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: HandyBoard Reset Vector
|
|
(...) Hi! If you start the Handyboard (no bootstrap mode) it is in the 'special test' mode. So the start vector is located at $BFFE and $BFFF. In your assambly program use the following code: Start_vec ORG $BFFE FDB Program_Start where (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Tone Functions
|
|
yep, 5 kHz is about the top end of the HB's 6811 capability. going higher would require dedicating the 'hc11 to generating the tone and doing nothing else. why? interrupt routine overhead. takes a bunch of cycles to handle an interrupt. the tone (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: HandyBoard Reset Vector
|
|
independent of IC, the HB fetches its reset vector at $bffe-$bfff. please see the FAQ about this: (URL) you, fred In your message you said: (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Tone Functions
|
|
I have a problem with the tone functions. I tried each of the following: 1000 - 9000 Hz tones for 2 to 3 seconds. All work fine up to 5000 but 6000 and above have broken up sound. Can anyone explain why this happens? What is the fix? -- ---...--- (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|