 | | Re: Sensor Power
|
|
(...) Take a look at the functions ds_power_on() & ds_power_off() as defined in the dsensor.c kernel file. When you've set the sensor to passive mode, you should be able to manipulate the sensor power bits using these functions[1] or just use the (...) (22 years ago, 6-Jan-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Motor Display
|
|
(...) This problem has been fixed in the most recent CVS source file (dmotor.c), but as far as I can tell it hasn't been part of an offical release yet: (URL) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: RCX low battery indicator problem
|
|
(...) I've tried the RCX2 firmware (firm0328.lgo). Same results: after downloading the firmware the RCX beeps (low battery signal) and is locked. In BrickOS when I read the battery sensor and write it's value on the display it says 620 (mV, Ithink) (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx)
|
| |
| | Re: The BrickOS Task Manager
|
|
tid_t -> thread ID pid_t -> process ID ? "nanobapt" <nanobapt@wanadoo.fr> wrote in message news:3FF95FD4.608020...adoo.fr... (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: New Robolab user saying hello!
|
|
In lugnet.robotics.rcx.robolab, Paul Britton wrote: <snip> I am an electronics test development engineer for satellite payloads and (...) <snip> Paul, you must have seen my 'Satellite Tracker'. If not, go to (URL) and navigate to that project. (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx.robolab)
|
