|
|
 | | Sensor Power
|
| ok, I have a real question. I'm interested in sending messages between RCXs using only the sensor ports. I've tested and found by switching between active and passive, signals can be sent, however, when the port is set to active, it is not powered (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Motor Display
|
| For some silly reason, I was browsing through the BrickOS code and I noticed this: void motor_a_dir(MotorDirection dir) { dm_a.dir = dm_a_pattern[dir]; dlcd_hide(LCD_A_LEFT); dlcd_hide(LCD_A_RIGHT); if (dir == fwd || dir == brake) (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx.legos)
| | | | | Re: nop in NQC?
|
| (...) you may try something like this: On(OUT_A+OUT_C); On(OUT_A+OUT_C); Off(OUT_A+OUT_C); or if you're looking for speed control, you could try: if (speed>5) On(OUT_A+OUT_C); else Off(OUT_A+OUT_C); if (speed>4) On(OUT_A+OUT_C); else (...) (22 years ago, 5-Jan-04, to lugnet.robotics)
| | | | | Re: Does RIS2.0 set use the fiber optics cable?
|
| "Luke W" <lwenke@dont_spam_me...tmail.com> wrote in message news:Hr03BI.1Bsz@lugnet.com... (...) Look right. I can't find any use for it in the instructions either. (...) of (...) In my RIS 2.0 set it is actually 25L (25 studs) long. What is the (...) (22 years ago, 5-Jan-04, to lugnet.robotics.rcx)
| | | | | Re: nop in NQC?
|
| (...) Try this: int i; i = i; Kevin (22 years ago, 5-Jan-04, to lugnet.robotics)
|
|
