To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3916 (+5)
  Re: any micromice out there?
 
Hi Brian, Several of my Penn State Abington freshman and sophomore engineering students constructed a working micromouse from LEGO and a HB. The approach was a vehicle that can only move in the north-south or east-west directions by alternately (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
 
  Re: LCD Removal
 
All pcodes shipped with IC 3.1/3.2 are designed to work fine either with or without LCD. Prior to 3.1, you have to build a pcode specially to disable the LCD. -- Randy (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
 
  Re: handshaking
 
(...) Regarding your earlier message, if you're just wanting to talk to a GPS, then you don't need handshaking, because I haven't found one yet that supports it. It is a simple three-wire interface to most GPS's, TX/RX and Ground. They don't support (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
 
  clock signal needed for decoder chip
 
Hello, I am hooking some HP decoder chips to the handyboard. They are HCTL-2020's and they decode a motor position encoder signal. My problem is that I need to hook one of the pins on the 2020 (the CLK pin) to a clock. I'd like to get ahold of the E (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
 
  Re: serial communications
 
Justin Here is the file. Please feel free to modify/improve. I'm a doctor not a programmer, and I better keep my day job. Notice it borrows Randy Sargent's and Dr. Richard F. Drushel's routines found in serialio.c and math.c, both on the handy board (...) (28 years ago, 9-Jun-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR