 | | Re: I'm passing the NQC torch...
|
|
Dear Dave, All I can Say is Thanks. But that says it all. JL (22 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: ROM image using USB tower
|
|
(...) Andrew, I grabbed a ROM image awhile back using a serial tower and an RCX 1.0. I haven't tried this on a 2.0 brick, but I think the ROMware is identical in all RCX versions. Although Kekoa's SEND.C uses the serial tower, it is not too hard to (...) (22 years ago, 12-Nov-03, to lugnet.robotics.rcx)
|
| |
| | Re: Alternate IR Comm Setups
|
|
(...) Dustin, I believe that the built-in IR in a laptop uses a different carrier frequency than the 38KHz used by the RCX 1.0. I've seen reports here that the 2.0 RCX can be reconfigured (with some low-level system programming) to use a 76KHz (...) (22 years ago, 12-Nov-03, to lugnet.robotics)
|
| |
| | Re: I'm passing the NQC torch...
|
|
(...) Dave, please allow me to add my name to the list of appreciative fans of your work, and the generous example you put forward to the LEGO/Mindstorms community. We all owe you a lot! -- Russ (22 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
| |
| | ROM image using USB tower
|
|
Hi, I'm doing a project at University involving developing some example programs running on a Lego RCX in order to demonstrate/teach OS concepts. I'd really like to get hold of a ROM image from the RCX, but I only have a USB tower available, and (...) (22 years ago, 12-Nov-03, to lugnet.robotics.rcx)
|
| |
| | Alternate IR Comm Setups
|
|
Has anyone attempted or had any success using the built-in IR ports on laptops to communicate with the RCX? Dustin (22 years ago, 12-Nov-03, to lugnet.robotics)
|
| |
| | Re: I'm passing the NQC torch...
|
|
(...) Please allow me add my sincere thanks to Dave for all the hard work he has put in over the last few years. As far as I am concerned, RIS only really appeals to me because of the access that NQC has permitted to the RCX. Were we to have been (...) (22 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Homebrew sensors (where to find them)
|
|
(...) I have used Pete's stuff. (URL) (22 years ago, 11-Nov-03, to lugnet.robotics)
|
| |
| | Re: I'm passing the NQC torch...
|
|
(...) Dave, Thanks so much for the work you have put into NQC. I have used this tool exclusively with BricxCC. You have changed the face of Mindstorms programming and for that I and I am sure many others are grateful. Thanks again, Dave (22 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: I'm passing the NQC torch...
|
|
(...) I too just wanted to say a huge THANK YOU for your hard efforts. Even them small changes you made for me to make it work better with my setup. I can honestly say that with our NQC the VLC's automation layouts would not have been possible. Your (...) (22 years ago, 11-Nov-03, to lugnet.robotics.rcx.nqc)
|
