 | | Serial port control in Robolab
|
|
Hallo there Does anybody know if it's possible to take control over COM port using Robolab (2.5)?? I searched through all the icons but didn't find anything useful. Can anybody help? Thanks in advance Robert (23 years ago, 20-Oct-03, to lugnet.robotics)
|
| |
 | | Re: Strange error message I have recieved
|
|
(...) Check out this message, it might address your problem: (URL) (23 years ago, 20-Oct-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Strange error message I have recieved
|
|
I am in the process of completing my senior project where I will add 3 additional allocation algorithms to the Memory Mangament facility in BrickOS. I should the Next Fit algorithm done but when I add a certain part of code I get the following error (...) (23 years ago, 19-Oct-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: More Spybotics NQC API stuff (work in progress)
|
|
Some slight revisions to the previous submission. And now I have finally figured out how to get the Spybot to control Manas. I'm very puzzled by the equations for setting the output bytes. Any explanations would be greatly appreciated. #include (...) (23 years ago, 19-Oct-03, to lugnet.robotics.spybotics, lugnet.robotics.rcx.nqc)
|
| |
 | | More Spybotics NQC API stuff (work in progress)
|
|
A lot of this is untested and very rough. For some reason I still can't get the Spybot to send out RC messages to a Manas unit. Sending an RCX message (opcode 0xF7) is quite simple - either using the ROM subroutine SendRCXMessage or by using the (...) (23 years ago, 18-Oct-03, to lugnet.robotics.spybotics, lugnet.robotics.rcx.nqc)
|