To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *37884 (-5)
  Install problems on Linux RedHat 9
 
Hi, I tried to install brickos-0.2.6.10 and have been unsuccessful. I started by going to rpmfind.net to get the h8300 binutils and gcc. The versions were: h8300-hms-binutils-2.11.2-1 h8300-hms-gcc-3.0.1-2 The brickos make failed with the following: (...) (23 years ago, 18-Jul-03, to lugnet.robotics.rcx.legos)
 
  USB/Serial Converter
 
Hi, folks. I've tried to connect to my RCX 1.0 (firmware 0328) from my laptop. Since I have only a serial IR tower, it works fine on my desktop PC, but communications won't work when I use a USB/serial converter to connect it to my laptop (there (...) (23 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
(...) (how the manual says to do data)? That's because I don't like to type more than is necessary! :-) Take this line for example: mov.b #0x02:8,r0h This line is doubly redundant. The destination operand is an 8-bit register so the other qualifiers (...) (23 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
Ok, the motor stuff makes sense, I got a little confused with the shift thing. I looked at the proggamming manual some more and it explaned the @ (Register inderect) but I don't see why it is needed, also in you example you specify the data as (...) (23 years ago, 18-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
A direct link to the page with the documents is (URL) Jürgen Stuber <stuber@loria.fr> (URL) rot 13 "fr" "se" (23 years ago, 17-Jul-03, to lugnet.robotics.rcx.legos)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR