To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *37619 (-5)
  Re: maze solving algorithm
 
(...) Can you post your source code please? Thanks, Jona <http:www.24tooth.com LEGO Robotics Group of Ann Arbor> (23 years ago, 16-Jun-03, to lugnet.robotics)
 
  Re: EGAD! (pneumatics)
 
(...) Yes, the switches would need to remember their last set state. Ideally, this would be done through the use of electric pneumatic switches which, when not receiving any power, simply stay in the last position they were set in. If this isn't (...) (23 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
 
  Re: EGAD! (pneumatics)
 
(...) IMHO, it would be much simpler and precise to measure directly pulse width instead of voltage, that could be done easily with a small microcontroller... Philo www.philohome.com (23 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
 
  Re: MOC - Small Pneumatic Biped Walker
 
(...) Hi Paul, I use a electronic schematic style when drawing out my pneumatic circuit designs these days. The combination of a piston that is linke to a pneumatic switch is simply a box, with X and C on the left edge, representing the eXpand and (...) (23 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
 
  Re: EGAD! (pneumatics)
 
(...) When using LEGO's firmware and NQC the maximum number of power levels you have is 8 (plus off?), so the most you can identiy is 9. This of course presumes that current draw by your compressor's motors doesn't mess with the voltage going into (...) (23 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR