To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3746 (+5)
  Re: Polarity of PowerJack from HB und Charger Board
 
on the interface/charger, since there's a bridge rectifier immediately normalizing the input jack voltage -- regardless of polarity -- it kind of doesn't matter which polarity you use. there is a discrepancy between the int/charger schematic and (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  Re: LCD Addressing - & - Expanded Mode
 
(...) You can only run the LCD when in single chip mode. (...) This leaves the chip in 'special test mode' that lets you go into and out of expanded mode by writing the config register. --Chuck (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Re: Controlling a DC motor 3
 
(...) Within limits, the rate doesn't matter much. What matters is the ratio of off time to on time (i.e., the duty cycle). Probably, you could change the frequency by an order of magnitude either way and get about the same results. --Will , , __@_/ (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Micromouse speed
 
Hi, does anyone know how fast should a micromouse move? and the other question is, will the 6811/handyboard have enough capability (address space) for maze solving? If not, what should I need? extra memory or 32bits processor? Thank you for any (...) (29 years ago, 4-May-98, to lugnet.robotics.handyboard)
 
  Re: DS1233 Monitor Chip
 
(...) I use an MC34064 on a 68hc11, and have never had any problem with it. Philippe Guermeur guermeur@ensta.fr (29 years ago, 4-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR