 | | recharging a battery the right way
|
|
hello I have a 6v 2.0amp battery. Its a lead acid battery. What is the right way to recharge it? The reason I ask is because I had a 12v 7amp battery from the same manyfacturer. I charged it using a car battery charger at the lowest setting (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Polarity of PowerJack from HB und Charger Board
|
|
Hi I am wondering about the Polarity of the Power Jack at the Handyboard and the charger board. At the HB the Pin in the middle is ground. At the charger board the outside Ring is ground.Can anybody tell me why it is different ? Thanks (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | IC communication problem
|
|
Hello, Lately I am having problems communicating with the handyboard after it is reset. I can download the pcode_hb.s19 file using hbdl.exe downloader. When the Handyboard is reset by toggling the power switch, the following is observed. 1st symptom (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | whoops, wrong test program
|
|
Attached to this message is the test program and S19 file for the LCD code. --Chuck (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | My LCD driver
|
|
Attached to this message is the LCD driver I wrote for the Handyboard written using ICC11. Feel free to use it. Some notes on it: The driver is designed to operate asynchronously. This is because the LCD can take several milliseconds to complete its (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|