 | | Controlling a DC motor 2
|
|
Hi again, I think i should change my previous question to the following. Is there any alternatives to control a DC motor motion (speed, direction etc) without using a motor driver? how? please explain briefly. Thank you for your replies. (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | My LCD driver
|
|
Attached to this message is the LCD driver I wrote for the Handyboard written using ICC11. Feel free to use it. Some notes on it: The driver is designed to operate asynchronously. This is because the LCD can take several milliseconds to complete its (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | whoops, wrong test program
|
|
Attached to this message is the test program and S19 file for the LCD code. --Chuck (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | IC communication problem
|
|
Hello, Lately I am having problems communicating with the handyboard after it is reset. I can download the pcode_hb.s19 file using hbdl.exe downloader. When the Handyboard is reset by toggling the power switch, the following is observed. 1st symptom (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Polarity of PowerJack from HB und Charger Board
|
|
Hi I am wondering about the Polarity of the Power Jack at the Handyboard and the charger board. At the HB the Pin in the middle is ground. At the charger board the outside Ring is ground.Can anybody tell me why it is different ? Thanks (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
|