To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3736 (-5)
  Controlling a DC motor 2
 
Hi again, I think i should change my previous question to the following. Is there any alternatives to control a DC motor motion (speed, direction etc) without using a motor driver? how? please explain briefly. Thank you for your replies. (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  Handy Board problem
 
I was wondering if anyone knows where I could purchase the Sharp Is1U60 IR detector. I have looked for it, however none of the distributors I have checked with even carry it. I tried Digikey, Mouser Electronics, JDR, Jameco, BG Micro, and others. (...) (29 years ago, 3-May-98, to lugnet.robotics.handyboard)
 
  MODB - How Is Expanded Mode Entered
 
If MODB pin is always grounded, how does the MCU get into expanded mode to access the 32K SRAM? The data sheet shows MODB HIGH to enter expanded mode. It show MODB LOW to enter single chip mode. What am I missing? -- ---...--- ipscone@halcyon.com (...) (29 years ago, 2-May-98, to lugnet.robotics.handyboard)
 
  Connections
 
Please forgive this probably silly question; as a software person I only dabble in hardware as a hobby: I want to make my own little expansion board and it requires signals from the expansion connectors of the HandyBoard. In particular I want to run (...) (29 years ago, 2-May-98, to lugnet.robotics.handyboard)
 
  6.270 board
 
What is 6.270? Where did this number come from? ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the Advancement of Science and Art (...) (29 years ago, 2-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR