|
|
 | | Re: 8475 Motor Tests
|
| (...) The limitation on the train controller is the wall wart - not the controller itself. There was discussion on this in .trains a while back. Someone built a tranformer box with about 3A output IIRC, and ran several trains with it through an (...) (23 years ago, 9-Jan-03, to lugnet.technic, lugnet.robotics)
| | | | | adding power inlet to technic control center
|
| Before I blindly go in and screw something up because of lack of electronics knowledge, has anybody already tackled this feat? I assume its very easy with a couple of diodes (maybe too easy) to isolate the batteries from the dc input, but I have (...) (23 years ago, 9-Jan-03, to lugnet.robotics, lugnet.technic)
| | | | | Re: 8475 Motor Tests
|
| (...) Holy C......... That's quite high (understatement) for a little LEGO motor. Do you think it's possible that the train controller I used in my test didn't produce enough juice? If that's the case, then the motor has a higher maximum stall (...) (23 years ago, 8-Jan-03, to lugnet.technic, lugnet.robotics)
| | | | | Re: Can't run software
|
| (...) Matthais, When I go to device manager and look for graphic cards there is no listing. I assume that means I don't have a graphics card and that is probably the real basis of my problem. Would that be right? Bill Lane (23 years ago, 8-Jan-03, to lugnet.robotics.spybotics)
| | | | | Re: unique Identifer in RCX
|
| With BrickOS, you could use the host address; which can be changed on the RCX using the view and program buttons. This would limit you to (what?) 8 or 16 RCXs, but that might be a start. // Joe (...) (23 years ago, 8-Jan-03, to lugnet.robotics)
|
|
