 | | Re: h8300-hms-ld segmentation fault under WinXP
|
|
"Joseph Woolley" <jwoolley@spamblock....ht.rr.com> wrote in message news:H4HvF3.C03@lugnet.com... (...) Win2k. (...) Ah, so it's not just me. I've been tearing my hair out trying to figure out what I might be doing wrong. A few years ago I had (...) (24 years ago, 24-Oct-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: h8300-hms-ld segmentation fault under WinXP
|
|
I don't think the problem is WinXP specific: I had the same issue on Win2k. I ended up using the prebuilt gcc/binutils from hitachi for that reason. However, the prebuilt set is quite a bit older. I hope this issue can be worked out so we can begin (...) (24 years ago, 24-Oct-02, to lugnet.robotics.rcx.legos)
|
| |
 | | h8300-hms-ld segmentation fault under WinXP
|
|
Hello, Are there any know problems getting the h8 cross compiler working under Windows XP? I'm using the latest cygwin environment, along with gcc3.2, newlib1.10, and have tried both the binutils source distributed with cygwin (2002070601?) and I (...) (24 years ago, 24-Oct-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Snaptrax remote control vs other Spybotics remotes control
|
|
(...) From my experience, The remotes, when first turned on, seem to send out the signals on all channels (1,2,3), until a specific channel is picked--then the remote only works for the robot that is on that specific channel. This happened with the (...) (24 years ago, 24-Oct-02, to lugnet.robotics.spybotics)
|
| |
 | | Re: Battery drain just to run a program?
|
|
(...) I think a switched on RCX that doesn't use sensors or motors draws ca 10mA, regardless of the program running. That's enough to drain batteries in a few days. Jürgen (24 years ago, 24-Oct-02, to lugnet.robotics)
|