 | | Speech Synthesizers
|
|
I am wanting to add speech to the Handy Board. I am currently looking at interfacing a SPO256-AL2 speech synthesizer chip and have a very limited schematic that came with the chip many years ago. Does anyone have a nice set of schematics for doing (...) (29 years ago, 16-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | L293D
|
|
where does the pwm go? ...the "cs" or the "in" pins? ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the Advancement of Science and (...) (29 years ago, 16-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Measuring PW
|
|
Has anyone been able to successfully use Thomas Hauri's PW measuring routines?? For some reason whenever I try to load them they crash my IC. Any thoughts?? Joshua Stark j-stark@uiuc.edu Aspiring Computer Engineering Major (29 years ago, 16-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | using the MC34064 LVI
|
|
Hello, This is a warning for anyone considering using the Motorola MC34064 to replace the DS1233. I have just built a couple handyboards and I had some problems getting them working. I finally tracked the problem done to the LVI. I used the MC34064 (...) (29 years ago, 16-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: pa7 9600 serial output
|
|
(...) You have to re-write the bit_delay loop to take up four times as much time. Just multiply the delay count value by four, e.g., "LDAB #148". Fred (following is the 9600 code.) * take up 0.1042 millisecs * 208 cycles bit_delay LDAB #37 bit_loop (...) (29 years ago, 16-Feb-98, to lugnet.robotics.handyboard)
|