 | | (no subject)
|
|
(29 years ago, 28-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: got 11
|
|
Hello, This is one of the bugs of IC3.1 The Pcode was loaded into the board sucessfully. You should quit the IC3.1 program. Then turn-off and on of the Handyboard. You will see IC3.1 message on the LCD screen plus a "beep" sound. Run IC3.1 program (...) (29 years ago, 28-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: a1e1
|
|
The major difference is A1' has 256-Byte RAM while E1' has 512-Byte. Basically, A1 can be replaced by E1 in Handyboard. Best Regards, Patrick --00---...--- Low cost MIT Handyboard supplier and Official Distributor of Interactive-C 3.1 ** An (...) (29 years ago, 28-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Non Volatile Memory 2
|
|
What are the power requirements of the battery backed RAM and would it be possible to set this RAM up with a lithium battery similar to a PC so that the RAM would hold its memory for several years? (29 years ago, 28-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | random dodgy sensor readings?
|
|
Hello folks, Is it normal to get invalid 'active' signals from the analog inputs every so often? I have made a lego buggy which seeks out its way from a darkish room into another room and to a window using a light sensor mounted on a sweeping servo (...) (29 years ago, 29-Dec-97, to lugnet.robotics.handyboard)
|