 | | Re: (MS)2 Expander Web Site Updated
|
|
Elegant! (...) (25 years ago, 14-Aug-01, to lugnet.robotics)
|
| |
 | | Re: WINLNP QUESTIONS
|
|
I did some more digging. When I look into the reg I do not find the reg keys as mentioned on the (URL) page. I dig in the code and set the com port by hand (directly to com1) and now I have the green ligth on the IR tower. However still no messages (...) (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | (MS)2 Expander Web Site Updated
|
|
I've updated my website with some changes to the building instructions for the (MS)2 Expander that might make it easier to build. (URL) Husby LUGNET Member #320 TFM's LEGO Workshop - www.akasa.bc.ca/tfm The Vancouver LEGO Club - www.akasa.bc.ca/vlc/ (25 years ago, 13-Aug-01, to lugnet.robotics, lugnet.robotics.rcx)
|
| |
 | | Re: ir communication
|
|
Yes there is. It is LNP it is availiable for windows or linux. I am just fiddling with the windows version see: (URL) I did not get it working just fine see also my post just before you (...) (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | ir communication
|
|
Hi, i am just doing my first steps with legOS and i want to send some data back to the PC. Is there any kind of software for the PC to read that data and save or display it? TIA Chris (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | WINLNP QUESTIONS
|
|
Dear all, I have some troubles setting up WinLNP. I am new to RCX (2 months) and legOS (1 month) and have not much experience with VC6. I want to set up a line of communication between PC and RCX. I downloaded everything from (URL) and I managed to (...) (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: transfer data failed
|
|
(...) One other thing, did you erase the firmware from the RCX before trying to load legOS? regards Frank Caggiano "The best education for the best caggiano@crystal-objects.com is the best education for all." (URL) Robert M. Hutchins Logo Users (...) (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: transfer data failed
|
|
(...) Did you try slow? (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: transfer data failed
|
|
(...) Did you try using the slow mode option ("-s" for firmdl3) as was suggested? (25 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Scout Problems
|
|
(...) Ben, Are you using the version of RcxCC from my website ((URL) If you are then I'm sure I can help figure out what is going wrong. But I can't say anything for sure based on what you posted. What is it that is not working when you try to use (...) (25 years ago, 13-Aug-01, to lugnet.robotics)
|