To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *28534 (-5)
  Re: NQC vs Spirit communication speed
 
The retry timing for RCX_Link uses a dynamic backoff, which is a good general purpose solution if you're going to be sending lots of packets (like a typical NQC download) and the latency through the serial driver is unknown and/or unpredictable (...) (26 years ago, 11-May-01, to lugnet.robotics.rcx.nqc)
 
  NQC vs Spirit communication speed
 
This is more a general RCX communication question, actually. As I mentioned here previously, I've ported the NQC communication code to Delphi for the purposes of modifying RcxCC to not use the Spirit OCX. At present I have a version of RcxCC that (...) (26 years ago, 11-May-01, to lugnet.robotics.rcx.nqc)
 
  Speed Computer?
 
It is not seperable. The wire comes out of the little sensor and goes straight into the display part. I had wondered the same thing. But I have not taken it apart yet! I ended up making my own rotation sensors using mouse parts. You get about 4 (...) (26 years ago, 11-May-01, to lugnet.robotics)
 
  Speed Computer?
 
Has anyone out there played with the Lego "Speed Computer" [5206] ? It appears to contain some kind of rotation sensor - I wonder if it could be made to work with the RCX - and perhaps avoid the missing count problems of the RCX's rotation sensor ? (...) (26 years ago, 11-May-01, to lugnet.robotics)
 
  Re: Dead Cybermaster, please help
 
I tried it with a motor that worked using a battery box, but I will check that again to be sure. I just had another idea, I will use the light elemement to see if there is any power coming from the C2. I may have to pursue some kind of compensation (...) (26 years ago, 11-May-01, to lugnet.robotics.cybermaster)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR