To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *27794 (-5)
  Re: I wish Lego made an "Anti-Backlash Gear"
 
(...) You can use those half beveled gears(with the recess) back to back as one gear, and one (maybe 2) crown gears as the gear on the other shaft. It depends on what the setup requires as of gear setup to work. Andy (...) (26 years ago, 4-Apr-01, to lugnet.robotics)
 
  Re: I wish Lego made an "Anti-Backlash Gear"
 
(...) Explain 'Hmmm...' :-) I of course omitted the fact that my solution as described produces no mechanical advantage just a shaft going in the opposite direction. Of course, you can always replace the pair of gears on the second shaft with a pair (...) (26 years ago, 5-Apr-01, to lugnet.robotics, lugnet.technic)
 
  Re: I wish Lego made an "Anti-Backlash Gear"
 
Hmmm... (...) (26 years ago, 5-Apr-01, to lugnet.robotics, lugnet.technic)
 
  Re: c++, classes
 
Hi Michael, if you want to use a declarator list in the constructor you have to use the following syntax: /******* Implementation of the constructor ***...***/ LightSensorHead::Lig...ensorHead( const Motor::Port motorport, const Sensor::Port (...) (26 years ago, 5-Apr-01, to lugnet.robotics.rcx.legos)
 
  Re: I wish Lego made an "Anti-Backlash Gear"
 
(...) I was going to say this solution is easy, but then I tried it. There are only two shaft's in this example. As lego don't make don't make a 'double width gear' You'd have to use four to make it in lego. All you'd need is three normal 16 tooth (...) (26 years ago, 5-Apr-01, to lugnet.robotics, lugnet.technic)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR