 | | Gearing down a lego motor
|
|
Hi, Before I invest a lot of time on this, what is the minimal gearing I need to do in order for a Lego motor to let itself up. How about a lego motor lifting itself and another motor up? I want the motor to be powerful but at the same time fast... (...) (26 years ago, 20-Jan-01, to lugnet.robotics.rcx, lugnet.robotics)
|
| |
 | | Re: LegOS 0.2.5 and LNP
|
|
(...) I cleaned up my code (found one bug!), the patch follows. As you may see now there are two semaphore, because two are the resources to give access to: the LNP buffer and the IR port. I modified the calling of the handlers to avoid race (...) (26 years ago, 20-Jan-01, to lugnet.robotics.rcx.legos)
|
| |
 | | Scout and External Iight sensor question
|
|
Hi all, I read once that it is possible to use an external light sensor on on of the 2 available input ports on the SCOUT in RAW mode. I attempted to do this with SENSOR_1 in NQC with little success. Here is what I have tried. (...) (26 years ago, 20-Jan-01, to lugnet.robotics.scout)
|
| |
 | | Sonar and the expansion board.
|
|
I am having quite a problem with getting the proper readings from the sonar. Here is a little background on what I have tried. I have a total of four driver boards and four sonar modules. I have soldered on the non-polarized tantalum 0.1uF (...) (26 years ago, 20-Jan-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: adder-subtractor ????
|
|
Could you give some directive to the maximum size of it in 'bricks'? It would be a challenge to make a small adder-subtracter with a small basis, although it would probably mean that it will become a little higher than usual. Jeroen. ___...___ Visit (...) (26 years ago, 20-Jan-01, to lugnet.robotics)
|