To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2551 (+5)
  Re: ? mobile base for handyboard
 
Depends on what you want to accomplish. The LegoBug can use otpical sensors to follow a black tape and the smaller 'micro-motors' are better (less play) than the standard 9v motors. check out (URL) for instructions, ordering info and a price list. (...) (29 years ago, 4-Aug-97, to lugnet.robotics.handyboard)
 
  IR output on HB
 
Hi, I'm trying to get the ir output on the handy board to power more than 4 LEDs (need to power 6), anything beyond that the ir signals become drastically weak. I have these LEDs wired serially. I'm not too familiar with electronics, so is it (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  3v motors
 
I have a cute little tracked robot base i want to run from a handyboard, but the problem is that it has 3V motors. The handyboard is set up to power 9v, right? The way i see it, i can either just put a resistor in series with the motor to drop the (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  3V motors
 
Mike, I had a similar problem and the solution is not to put a resistor in series with the motors. With the varying amount of current a motor draws, the voltage drop across the resistor will vary as well and the motors will not see a consistent 3V. (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  CdS cells
 
hi everyone, I am looking to purchase a batch of CdS photo cells but I think that I need more information before I order. The catalogs (Digi-Key, Mouser, etc.) list several different photocells (different resistances, power dissipation, etc.) and I (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR