To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *23239 (-5)
  Re: Casters
 
(...) When the vehicle is rolling towards the caster, the caster is much closer to the drive wheels, and they have a lot more leverage against the caster to position it where they want. When it's rolling away from the caster, the caster is so much (...) (26 years ago, 22-Aug-00, to lugnet.robotics)
 
  RE: Casters
 
>A good point, but wouldn't the effect of torque tend to disappear after the >initial inertia disappears (i.e., when the robot was no longer accelerating, >but rather moving at a steady pace). I suspect that inertia is only small part of the what (...) (26 years ago, 22-Aug-00, to lugnet.robotics)
 
  RE: Casters
 
A good point, but wouldn't the effect of torque tend to disappear after the initial inertia disappears (i.e., when the robot was no longer accelerating, but rather moving at a steady pace). I can experiment with this by adjusting the center of (...) (26 years ago, 22-Aug-00, to lugnet.robotics)
 
  Re: Casters
 
It might be thus: When the motors engage, there's some torque in the body that would tend to lift the nose of the vehicle up (think of a dragster, how it pops a wheelie under acceleration). Thus, when under acceleration, the front of the vehicle is (...) (26 years ago, 22-Aug-00, to lugnet.robotics)
 
  Casters
 
Can anyone explain to me why front-mounted casters, with the powered wheels toward the back of the robot (see photo at www.wordsmithdigital...iaries.htm ), stay in alignment better than rear-mounted casters with the wheels in front? I can't quite (...) (26 years ago, 22-Aug-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR