 | | Re: How can RIS talk to Cybermaster
|
|
(...) Two ways I know. 1. There is a program for the PC that will translate the Radio signal into IR and back again. 2. Take a connector and put it on the motor port of the master unit and put it to a sensor port. Now toggle the master unit's motor (...) (27 years ago, 6-Apr-00, to lugnet.robotics.rcx)
|
| |
 | | Dark Side Developer's Kit at Toy World
|
|
In the May 2000 issue of Lee's Action Figure Guide, there is a full page spread on the Dark Side Developer's Kit. One of the alternate models is a _very_ cool looking Destroyer Droid, a la Episode I. Check it out, if you get a chance (and can find (...) (27 years ago, 6-Apr-00, to lugnet.robotics, lugnet.starwars, lugnet.off-topic.geek)
|
| |
 | | Re: 5V of trouble
|
|
those two things together strongly suggest that your crystal isn't running. any chance you can get a scope or logic probe to verify this -- measure the E clock output of the 'hc11 (pin 5). also, check that you've properly installed a 2.2 megaohm (...) (27 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
 | | How can RIS talk to Cybermaster
|
|
Hello Sorry but i didn't find an answer in the Newsgroups. So how can a RIS talk to a Cybermaster System ? Thanks Karsten (27 years ago, 6-Apr-00, to lugnet.robotics.rcx)
|
| |
 | | 5V of trouble
|
|
i'm assembling the handyboard according to the instructions found on the HB site. When measuring the E clock signal using a voltmeter, i register 5V instead to the anticipated 2.5V. i've re-checked all the solder joints but there doesn't appear to (...) (27 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|