To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1546 (+5)
  Re: IR collision avoidance
 
(...) Good question! We had a lot of noise problems and learning curve stumbles along the way. Our first bad news was that we had a range of a few inches. We finally beat that one fooling with frequencies, caps, etc. and then found out our range was (...) (30 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
 
  timing
 
Hi- I'm attempting to write an assembly routine to control a pulse width, but I can't seem to get the timing down. For example, I can output a 3.33ms pulse width, but if I run the routine again, it sometimes jumps to 3.5ms, and then jumps back down (...) (30 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
 
  Re: timing
 
(...) Mike, Not enough info to determine your problem. Are you using the Output Compare functions, or are you trying to emulate that functionality some way? The OC lines are hardware-set, so they go off whenever the free-running counter matches some (...) (30 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
 
  LCD display
 
Hi, Is there any way to disable the LCD display? Rather the heartbeat. I'm not using the LCD, and I don't want anything printing the the LCD, heartbeat included. Thanks, Maria ---...--- Maria Pirsic IEEE Branch Treasurer 96/97 Carleton University (...) (30 years ago, 28-Feb-97, to lugnet.robotics.handyboard)
 
  use of single power source op amp circuits with the Handy Board
 
Does anyone know how to get a negative 5 volts from the Handy board for an op amp amplifier circuit or set equations to figure out the gain of an standard op amp as the 741 or LM339 using Vee as ground and Vcc as +5 VDC? The equations only seem to (...) (30 years ago, 28-Feb-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR