 | | Re: Motors & handyboard
|
|
(...) What is 20? (...) Current meters have an internal resistance. The lower the current range the larger the resistance --- even with digital current meters. Some typical values For example: Digital Analogue Current Range R_meter R_meter 200 uA (...) (30 years ago, 17-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | problems downloading own .asm
|
|
Look at the .s19 file, and see if it's downloading anything between 0 and FF. (You should be able to stare at your .s19 file and the pcode for a while and figure out the 4 hex bytes which contain the address for a line). Downloading something to the (...) (30 years ago, 17-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | HELP!
|
|
I hope that someone reading this can please help me with a problem that I am finding difficult to solve. I have completed section 4.3 "Micropro and Oscilaator cct" and confirmed that the oscillator is running. However after section 4.4 "Serial line (...) (30 years ago, 17-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: downloading
|
|
(...) Did you run the strip_cr utility on the .S19 file to make the file's lines end correctly? * Michael L. Ross/C33 | Lockheed Martin Eng & Sci Svcs Co. **** * Robotics Department | 2400 Nasa Rd. 1, Houston, TX 77058***** * (281)333-7094; (...) (30 years ago, 17-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re[2]: expansion board
|
|
Actually I wanted an analogue signal giving some idea of distance. I've done it with a 555 oscillator for illumination, and an opamp demodulator circuit. I was thinking that this might be useful on the expansion board. Richard ___...___ Reply (...) (30 years ago, 18-Feb-97, to lugnet.robotics.handyboard)
|