 | | Ha! (was Re: proud of myself (+ some questions))
|
|
Got up in the middle of the night, moved the slip-clutch to a different position in the drive train (now attached directly to the motor shaft, in fact). Get much better results -- can drive across carpet without breaking a sweat. Should have thought (...) (27 years ago, 17-Sep-99, to lugnet.robotics, lugnet.build)
|
| |
 | | Re: proud of myself (+ some questions)
|
|
(...) in the case you have a spare touch sensor can make a tachometer. Since you always know the direction your steering is running, you can count the teeth and know exactly where it's positioned. It's pretty easy to setup: (URL) Martins [ (...) (27 years ago, 17-Sep-99, to lugnet.robotics)
|
| |
 | | Re: proud of myself (+ some questions)
|
|
(...) VERY clever! Almost as good as a rotation sensor. I'll have to try this. (27 years ago, 17-Sep-99, to lugnet.robotics)
|
| |
 | | Re: proud of myself (+ some questions)
|
|
(...) second (...) As part of a different project, I wrote a snippet of code that would maintain a specific speed regardless of the surface. It's based on a rotation sensor target vs. time. If it's going too slow, the motor speed is bumped up by (...) (27 years ago, 17-Sep-99, to lugnet.robotics, lugnet.build)
|
| |
 | | Re: Decoding the LEGO IR remote control
|
|
In light of the underwhelming lack of response to my LEGO IR post, maybe I need to clarify a little: The RCX tower and the LEGO remote control (#9738) both transmit a 38kHz carrier which is modulated at a 2400bps rate. The encoding is 8 data bits, (...) (27 years ago, 17-Sep-99, to lugnet.robotics.rcx)
|