To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *13626 (+5)
  Re: r/c servos
 
If the pwm is really being controlled by an 8 bit counter, that might be fine for the servos. The current rcx output has a cycle time of 8mS and uses 1mS increments. If those are the top 3 bits, then the resolution is 5 bits worth or 0.03mS. This (...) (27 years ago, 20-Aug-99, to lugnet.robotics)
 
  Re: r/c servos
 
(...) It is a software-based PWM. The topic of controlling a servo with the RCX has been discussed before. Generating the pulse stream for a servo would not be too difficult with the RCX, assuming you program the H8 directly using e.g. LegOS or (...) (27 years ago, 20-Aug-99, to lugnet.robotics)
 
  Re: r/c servos
 
(...) To get rid of the speculation here, the PWM is controlled by a programmable timer that the code in ROM configures to generate an interrupt every 1 ms. Output for each of 8 power levels is stored in a small table of waveforms, with the 1 ms (...) (27 years ago, 20-Aug-99, to lugnet.robotics)
 
  RE: Droid Dev. Kit, reprise
 
Or could it be that new 2 in 2 out screen programmable (blue RCX) RIS? JT -----Original Message----- From: Ray Sanders [mailto:rsanders@gate.net] Sent: Friday, August 20, 1999 6:03 AM To: lego-robotics@crynwr.com Subject: Re: Droid Dev. Kit, reprise (...) (27 years ago, 20-Aug-99, to lugnet.robotics)
 
  RE: X10 X-Cam
 
Don't buy the X-10 system expecting to use it for robotics. Those 2.4Ghz transmitters are directional and therefore are not well suited for the robotics application. Go to Best Buy or shopping.com etc. and buy a 900Mhz transmitter/receiver (actually (...) (27 years ago, 20-Aug-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR