 | | H-bridge
|
| Hello, Does anyone know if there is a vendor that sells a H-bridge that is ready to be used for the Handy-board, instead of me having to wire up a National Semiconductor LMD18200. Thanks for your time guys. Juergen Lunkwitz Drexel University (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | |  | | Motion sensor
|
| Hello all, Thank you for all of your kind help in the past. Here is another question that I hope is worthy of your time... I have a motion sensor purchased from Acroname (Eltec, I forget the part number). It works, as I had written a small program (...) (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | |  | | Re: Motorized Cyberslam Cannons
|
| I have a bank of four triggered by cams on an axle. It's 12 studs wide. The axle is driven by a chain drive. I'm using a rotation sensor to control individual firing. Sorry, no digital camera, no photos. (...) (27 years ago, 14-Jun-99, to lugnet.robotics)
| | |  | | Re: Lego Network Protocol questions
|
| Ralph Hempel wrote in message <000001beb0e4$f9d0df...pro150>... (...) I'll back you up on this as well. I did some experiments using two towers connected to two different PCs, and found that I could send raw bytes from one PC to the other without (...) (27 years ago, 14-Jun-99, to lugnet.robotics.rcx.legos, lugnet.robotics)
| | |  | | IRPD sensors
|
| I have gotten some Infrared Proximity Detectors (IRPD), but no instructions for using them with the handyboard. These are set up with an infrared LED on each type of the sensor, and they are intended to give left/right/front detection. The program (...) (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| |