To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1136 (+5)
  Handy Board Crash
 
Hi, I was installing another user knob beacuse the other one broke. While I was in the middle of doing it, I think I fried the board. When I start up I have an led sequence like this: green green green red does anyone know what this means, if so (...) (30 years ago, 19-Dec-96, to lugnet.robotics.handyboard)
 
  Re: Handy Board Crash
 
(...) I'm assuming you mean the motor LED's and that they stay on and nothing shows up on the LCD. Sounds like you didn't disconnect the battery and accidently shorted it. Probably lost the contents of the RAM. Try reloading the Pcode. hope it works (...) (30 years ago, 19-Dec-96, to lugnet.robotics.handyboard)
 
  Newcomer
 
Hello: First - thanks for all the good information that we were able to find on the handyboard web page and on the associated ftp site. My son and I have decided that we would like to build the handyboard rather than buy one ready-built. We have no (...) (30 years ago, 19-Dec-96, to lugnet.robotics.handyboard)
 
  Re: Newcomer
 
(...) either. some people like the e1 better because it has more flexible timer and counter lines. but the a1 has a simpler bootstrap sequence and is less likely to have compatibility problems with the host computer. (...) No, it's harder than this. (...) (30 years ago, 19-Dec-96, to lugnet.robotics.handyboard)
 
  Re: Handy Board Crash
 
(...) Re-load pcode_hb.s19. If the board loses its operating program, when it starts up it runs gibberish, and the value of the motor output latch is randomized. -Fred (30 years ago, 19-Dec-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR