 | | Re: T3 Board colors & rules
|
|
(...) No need to do that. My prototype sits completely behind the board. It doesn't extend along either side of the board. Speaking of which, I finished up the controls last night. I've just got a little bracing I'd like to do then it is on to (...) (19 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
| |
| | Re: T3 Board colors & rules
|
|
(...) I'm going to go with John on this. But only because I don't want him to have to start over, and I doubt it will affect Brian. :) (...) Sounds good. I have a BrickOS program that I made up to keep time. If I can find it, I'll post it. Steve (19 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
| |
| | Re: T3 Board colors & rules
|
|
(...) LDraw is actually much easier to start using than I thought. The interface is a little cumbersome, but nice. The lego pieces practically snap into place (but not the technic pins & stuff, they're trickier). I have only scraped the surface of (...) (19 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
| |
| | Re: T3 Board colors
|
|
(...) Someday I'll have to learn LDraw (or more likely LDD at this point). Very nice work John. It looks like it's one brick and one plate high? (...) I wish it was symmetric, but that can't work unless we make all the cells 6 wide. One point - we (...) (19 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
| |
| | Re: T3 Board colors
|
|
(...) With this being said, I've re-done the T3 board in LDraw. You can see the latest version here (when it goes public) (URL) The basics: baseplate-- green, cubes-- white & black, surround-- black, crosshatch plates-- gray If anybody sees a (...) (19 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
