 | | Re: Weeping Willow
|
| (...) Ok, now that we've got all our directions sorted out, I've found a new location for the RCX. :) It's inside the northern-most piece of mountain. The hole for IR commands faces east, towards the rest of the layout. You can also run wire out (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
| | | | | Re: Weeping Willow
|
| (...) Great. Here's what will need to get to and from the RCX. The power cord (Same as a train Power plug) one wire going out to the Sensor east. Another sensor inside the mountain (so we know when the train has cleared the switch) A motor wire (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
| | | | | Re: Weeping Willow
|
| (...) WhoMping, WhoMping, WhoMping !!! Robin (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
| | | | | Re: Weeping Willow
|
| (...) Snicker... Dean (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
| | | | | Re: Weeping Willow
|
| (...) Ok I think I've left enough room for all of the above. But why do we need a (motor?) wire running to the track? Also, I'm not quite clear as to the sensor you're talking about... Do we have to place it inside the mountain? Perhaps the dry-run (...) (23 years ago, 24-Jul-01, to lugnet.org.ca.vlc)
| | | | | Re: Weeping Willow
|
| (...) If you want the train to stop at the station you must isolate the track and run it by the MS. (...) There is one magnet sensor before the switch track. And there is a light sensor just after the switch track. (...) Yes. I have 7 more sensors (...) (23 years ago, 24-Jul-01, to lugnet.org.ca.vlc)
| |
