 | | Turn table ideas
|
| Hi Guys, Well my round (rectangular actually) House is near completion. I need about 42 - 50 3 x 4 33 degree red slopes to finish it off (does any one have any that they want to sell? and I still have to do some interior detailing. The turntable is (...) (24 years ago, 12-May-01, to lugnet.org.ca.rtltoronto)
| | | | | Re: Turn table ideas
|
| "Jeff Van Winden" <Jvwinden@sympatico.ca> wrote in message news:GD8Cwt.7pK@lugnet.com... (...) impossible (...) If the sensor was mounted directly off the shaft of the turntable itself the resolution would be far from desirable, espically for (...) (24 years ago, 12-May-01, to lugnet.org.ca.rtltoronto)
| | | | | Re: Turn table ideas
|
| (...) <snip> (...) Can you space the 2 1x2 brick apart and use a bushing between them to hold the axle in place? Martin <more snip> (...) (24 years ago, 12-May-01, to lugnet.org.ca.rtltoronto)
| | | | | Re: Turn table ideas
|
| (...) How accurate is the rotation sensor at high speeds? (...) Thanks for the Idea Iain, I'll try that this afternoon amd let you know how it goes.... (...) (24 years ago, 13-May-01, to lugnet.org.ca.rtltoronto)
| | | | | Re: Turn table ideas
|
| (...) Unfortunatly not, I only have a 5 stud area to work in, at 6 studs the bricks would hit the drive motor. Jeff (...) (24 years ago, 13-May-01, to lugnet.org.ca.rtltoronto)
| |
