Subject:
|
Re: rtl10.1 Playfield
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Fri, 8 Mar 2002 16:07:53 GMT
|
Viewed:
|
439 times
|
| |
|
|
I managed to slap together a robot this morning in about an hour and half.
After fixing one major design flaw, I was basically covering up the IR port, I
discovered it's about a 1/4 inch too long. I hope this isn't a problem. I'll
definitely build a complaint robot for the actual match.
I didn't get to do any programing for it, in fact it doesn't even have the
correct firmware.
Its a simple robot, two motors, skid steering.
Derek
|
|
Message has 1 Reply:
 | | Re: rtl10.1 Playfield
|
| (...) what about a kicking device??? Each of mine has 4 motors (1 for each rear wheel to allow steering / and to give it some horse power, and 2 motors for the kicking device). As for the firmware, its the firmware included on the RIS 1.5, with what (...) (23 years ago, 8-Mar-02, to lugnet.org.ca.rtltoronto)
|
Message is in Reply To:
| | rtl10.1 Playfield
|
| The rtl10.1 Playfield, aka, the Interactive Media Lab conference table, is a large old table 48x72 inches, a big rectangle. FYI. Calum (23 years ago, 7-Mar-02, to lugnet.org.ca.rtltoronto)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
