 | | Re: R/C skid steer test —Nathan Bell
| | | | (...) Nice! Can it steer while also moving forward, or does the switch work with just a 3-position action (turn right/go straight/turn left)? Could you also use 3 12-tooth gears for the side opposite the 2 24-tooth gears, or did you use the 2 (...) (18 years ago, 6-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | | | | | | Re: R/C skid steer test —Rob Antonishen
| | | | | (...) Oh yes! it can steer when going forward. With the current gearing though, it spins out. I should try to drive the adder/subtractor input with an 8-tooth gear rather than the current 24 to slow the turning rate down. Though I suppose I couldn't (...) (18 years ago, 7-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | | | | | | | | Re: R/C skid steer test —David Wegmuller
| | | | | (...) Hi Rob, You might consider using the auxilary output of the RC to control a gear shifter to select between "driveable" and "mad spining" modes... Using the polarity switch is brilliant! I tried a pure mechanical solution (the steering (...) (18 years ago, 9-Feb-07, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | | |
