| |
Anyone know of software that will let me input a bunch of parameters,
and it would spit out optimum brick/plate and gear size ratios?
I have a 24t in a bean, and horizontally on either side, I have a 40T
being synced by the 24'. I want to drive the 24t with something less
then the full RPM of the new technic motor.
Above the beam with the 24t is PLATE/PLATE/BEAM. any ideas? Right now,
I can put a motor on top of the 2nd beam, and drive the 24t with a 40t.
but that just gives me 1:1
Chris
|
|
Message has 1 Reply:
 | | Re: Gear train software
|
| (...) yeah - Excel. I made a similar set of tables for diagonal bracing...I can dig it up if you want. IT might give you the starting point you need. -Rob A> (19 years ago, 28-Dec-05, to lugnet.org.ca.rtltoronto)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
