 | | Re: RC racing track width —Calum Tsang
|
| | | (...) The only restrictions are: -Made of Lego, usual rtlToronto building requirements -uses the 8475/8366 Racer controller/receiver pair (ie, not the new outdoor RC or the old 5600 RC) That's about it. (...) I always wanted to get into RC, sigh. (...) (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: RC racing track width —David Koudys
|
| | | | | In lugnet.org.ca.rtltoronto, Calum Tsang wrote: <snip> (...) Dave K (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | | Re: RC racing track width —Jeff Van Winden
|
| | | | | | (...) Ok, so before I answer this, I would need to know when it is? Probably discussed at dinner, but since I was not there.... Jeff VW (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
|
| | | | | | |
| | | | | Re: RC racing track width —Derek Raycraft
|
| | | | (...) I'll attempt to write a timing and scoring application like I did for C$. If I don't get it done a traditional lap sheet and pencil will do. Derek (20 years ago, 14-Mar-05, to lugnet.org.ca.rtltoronto)
|
| | | | |
